lsidrivemap.sh

This script displays drive information in the order they are inserted in the bays of your rack mounted storage. It is similar to louwrentius/lsidrivemap, but for LSI controllers that use the sas2ircu configuration utility instead of megacli. These are controllers which uses on of these chips: LSISAS2004, LSISAS2008 LSISAS2108, LSISAS2208, LSISAS2304, LSISAS2308

Install

wget https://raw.githubusercontent.com/pimlie/lsidrivemap.sh/master/lsidrivemap.sh
chmod +x lsidrivemap.sh
sudo mv lsidrivemap.sh /usr/local/bin/

• Next download the sas2ircu utility from the LSI/Avago/Broadcom website and copy the utility to e.g. /usr/local/bin
• Edit the lsidrivemap.sh script and adjust the driveMap to your situation. The numbers used are the controller numbers & drive numbers retured by the sas2ircu utility (run sas2ircu info to list the controllers and sas2ircu <controller_number> display to show the driver numbers)

Usage

$ lsidrivemap.sh -h
Usage: /usr/local/bin/lsidrivemap.sh [-c] <path> [option]

option information:
  -c <path>     The path to the sas2ircu configuration utility
  -d            Show the disk type
  -f            Show the firmware of the drive
  -s            Show the disk state
  --smart <num> Show the specified smart attribute
  -n|-sn        Show the drive serial number
  -t            Show the temperature of the drive, alias for --smart 194
  -w            Show the world wide name (wwn) of the drive
  -h            Display this message

Example output

Note that one drive was missing in my system

$ lsidrivemap.sh
-------------------------
| sdq | sdm | sdi | sdc |
| sdp | sdl | sdh | sdf |
| sdo | sdk |     | sde |
| sdn | sdj | sdg | sdd |
-------------------------
$ lsidrivemap.sh -t
---------------------
| 37 | 35 | 34 | 33 |
| 37 | 36 | 32 | 30 |
| 38 | 32 |    | 29 |
| 32 | 31 | 30 | 29 |
---------------------
$ lsidrivemap.sh --smart 5
-----------------
| 0 | 0 | 0 | 0 |
| 0 | 0 | 0 | 0 |
| 0 | 0 |   | 0 |
| 0 | 0 | 0 | 0 |
-----------------

Requirements

You need to have udev installed to populate /dev/disk/by-id/wwn-0xXXXXXXXXXXXX. The sas2ircu utility returns the WWN / GUID and we use that to retrieve the device mapping (/dev/sdX) and run smartctl commands on. Surprisingly you also need smartctl if you want to return smart values.

Tested

Tested on Ubuntu 14.04.3 LTS, 16.04 LTS, 18.04 LTS with Dell H200 controllers flashed to LSI 9211-8i P20 firmware